Most start sequences follow the same pattern, but clubs change the details, and the details are where people get caught out. This is how the standard sequence works, the common variations, and how to keep your timer matched to the committee boat.

The standard five-minute sequence

Rule 26 of the Racing Rules of Sailing sets out the default sequence:

The flags are the signals. The sounds only draw attention to them, and if a horn fails or goes off late, the time is taken from the flag. When you are syncing a timer, watch the flags rather than listening for the horn.

The preparatory flag also tells you which rules apply. P is the plain version. I, Z, U and the black flag each add a different penalty for being on the course side of the line late in the sequence. They are covered in rules 30.1 to 30.4, and it is worth knowing which one your club uses before you need to.

Shorter sequences

Many clubs run three-minute sequences for dinghies, particularly for training and short-course racing. The usual version puts the warning signal at 3 minutes, the preparatory signal at 2, the one-minute signal at 1 and the start at 0. Team racing and practice starts sometimes use even shorter ones.

Any change from rule 26 has to be in the sailing instructions, so read them before you go out. The sequence you know from your own club may not be the one used at a regatta.

Rolling starts

When several classes start one after another, the warning signal for the next class is usually made at the starting signal of the class before it. With a five-minute sequence that gives a start every five minutes. If your class goes third, you need to know which signal is your warning rather than starting the clock on the first horn of the day.

Postponements and general recalls

When the answering pennant (AP) is lowered, the warning signal is made one minute later. After a general recall the same applies to the First Substitute: the warning signal follows one minute after it comes down. Either way you get a minute’s notice, which is enough time to reset your timer and be ready to start it.

Pursuit races

In a pursuit race each boat or class starts at its own time, set from its handicap, so the slowest boats start first and the first boat across the finish line wins. Instead of counting down to a common start, you count down to your own start time, which may be well after the first boats have gone. Start times are usually published as minutes and seconds after the first start. Our pursuit race timing guide covers this in more detail.

Keeping your timer in sync

Start the timer as the warning signal flag goes up. If you miss it, the preparatory and one-minute signals give you two more chances to correct it.

In Regatta Racer, start the countdown at the warning signal and press Sync at each later signal. Sync rounds the countdown to the nearest whole minute, so pressing it as the preparatory flag goes up puts you on exactly 4:00 even if you started a few seconds out. Because it rounds to the nearest minute, press it within 30 seconds of the signal.

Before you start the countdown you can change its length a minute at a time, which helps when the race committee runs a shorter sequence than you expected. For pursuit races, use the pursuit option and enter your own start as a time of day, in hours, minutes and seconds. The countdown runs to that time on both the phone and the watch. If your start is published as minutes after the first start, add it to the first start time.